Fire Lane Striping in Mobile, Alabama
How You Should Establish A Fire Lane in the Parking Lot
In urban areas, a fire lane is marked in a parking lot near any building. Normal traffic is not allowed to park in the fire lanes to make sure that in case of any emergency the access to safety equipment is done without any hindrance. These lanes are also defined as a passageway to access roads that allow fire department vehicles to pass through easily. When a fire lane is designed in any area, there are some requirements that need to be fulfilled first.
Since fire trucks and other fire department vehicles are huge, therefore, some adjustments, need to be made for them. Fire lanes also provide a clear space to escape from. Consequently, they need to wider for buildings with large occupancy.
Parking Lot Fire Lane Requirements
Fire lane striping is required in various locations depending on the land which is being used. These markings are also required for specific fire apparatus access features like turnarounds. The fire department access should be twenty-six feet wide or less on both sides of the road. One side of the fire department access roadways with widths which is greater than twenty-six feet and can go up to thirty-two feet.
There are four ways to mark the fire department turnaround when needed for a specific site. The entrance of the turnaround is marked differently depending upon the width of the roadway which can or cannot be based on the zone of the site. Apart from marking the parking area for the fire lane, installing signs are also a requirement.
Contact Us Today For a FREE Quote!
We provide parking lot striping for the entire
Mobile, Alabama Area